JMT PCIE 3.0 x16 to x16 Riser Cable Jumpers TX to Tx Direct Flat Extension Cable TX to RX Signal Swap Support GTX1080ti GTX2080ti RX5700xt RTX3060 (15cm,R33FF)

Product description: Brand name: JMT Product name:PCIe x16 jumpers cable For model R33SF/SL/SR, the distance between the positioning screw holes is 10.8cm. K33NS: PCIe 4.0 x16 Gold Finger Flat to x16 Gold Finger Flat, Male to Male, PCIe TX-RX Signal Switch Cable Note: 1. When inserting the cable, it is necessary to have a clear understanding of the direction, do not insert the socket in reverse or out of alignment, to avoid burning the device. First hold the socket of the device before inserting the cable, to avoid cutting the socket pin too hard.No bending and no pulling within 2cm of the welding of the second end of the wire and the circuit board. 2. All kinds of motherboards and equipment signal driving ability and other conditions are not the same, as long as it is connected to the extension cord, the signal will be lost. 3. A graphics card or motherboard is an electronic device that will age and oxidize over time, and the extension cord will only become more unstable.Old devices more than three years are not supported . 4. The extension cable is assembled incorrectly. The graphics card extension cable should be installed in the graphics card slot nearest the CPU. Other graphics card slots have poor performance and cannot reach full speed performance. 5. Although the motherboard has a 16x interface, the PCIe slot pins of the motherboard may not be full. Without full pins, it will not be able to reach x16. 6. The golden fingers of the graphics card or the motherboard socket terminals are not in good contact or have oxides, causing the card to slow down, and the golden finger contact points should be clean.

• If your applications uses a mother board that needs to link to another PCB via PCIe, and that PCB has PCIe connectors instead of edge fingers, then this PCIe Jumper Assemblies may fit your need. All of the speed and flexibility of the original Extender Assemblies, but for card-to-card applications.For model R33SF/SL/SR, the distance between the positioning screw holes is 10.8cm.
• Imported wire with German patent, connector imported from Taiwan, support PCIe 3.0 full speed stable transmission.Wire impedance is low, line length within 60 cm support PCIe3.0 full speed,128G/bps (Max).The length of the wire refers to the part of the visible wire. It does not include the PCB and the connector.
• The differential signal has no hole design, and there is no signal attenuation interference problem of parasitic capacitance and parasitic inductance, and no CAF micro-short circuit phenomenon. The product is durable.PCB dwarfing and fatten design, dwarfing will not be stuck to the graphics card, fatten and lengthening design makes the board card easier to install, reduce the probability of damage.
• The products are made of high quality materials, PCB is made of fine workmanship, copper is thickened to 1oz, gold finger has enough gold plating content and good electrical conductivity, which can reduce the problem of dead blue screen caused by increased oxidation rust impedance.
• The wire selected by the product itself is very durable, the use of the thickness of 3mm PCB gasket protection in the metal welding point, and lock the screw and hexagon nut fastening, the product is solid and reliable tensile resistance, anti-interference, there will not be broken wire nail problem.The thickness of the wire is 1.4mm, can be bent or folded, do not affect the use.